| Settings |
Selects a pre-defined set of Plot2EMF configuration
options. |
| Save As... |
Saves the currently defined settings under a new
name. |
| Delete |
Deletes the selected named settings set. |
| Pen Settings |
Displays the Pen
Settings... dialog box, to define the
color and thickness of each pen. |
| Automatically Copy to the Clipboard |
Check this option to automatically copy the MetaFile to
the Windows Clipboard when a HP-GL file has been
converted. |
| Don't close after starting via document |
Check this option to prevent Plot2EMF from
automatically closing after converting a plot file that you
have double-clicked. |
| Don't display success messages |
Prevents the display of the "file.plt converted
into file.emf and copied to the Windows Clipboard"
information message. |
| No 'not implemented' warnings |
Prevents Plot2EMF from logging warnings for
non-implemented HP-GL commands including CA[n]; CS[n]; PG;
PW[n]; SA; SL[...]; SS; UC[...]; and VS[n];. |
| Ignore all warnings |
Prevents Plot2EMF from displaying a pop-up message
even if warnings or errors were recorded. |
| Don't save log files when successful |
Plot2EMF deletes the .LOG file when no warnings or
errors have been recorded. |
| Don't save EMF file (clipboard open) |
Plot2EMF won't save the EMF file after creation. Use together with
Automatically Copy to the Clipboard to convert a HP-GL file
into the clipboard only.
|
| Don't optimize arcs and circles |
When checked, Arcs, circles and wedges will be drawn as
a series of line segments, rather than with curve
commands. |
| Device Initialisation "IN;" implied |
When checked, the rendering engine assumes an "IN;"
command before processing the selected file. |
| Convert text from ASCII to ANSI |
When checked, text plotted with the LB; (Label) command
will be converted from the ASCII (DOS) to ANSI (Windows)
character set. |
| Emulate HP Laser Jet |
When checked, Plot2EMF will ignore all commands until
the sequence Esc%#B is found. Do not use this option
unless you are sure that your plot file contains this
Escape sequence! |
| Use High-Resolution Mapping Mode |
When checked, Plot2EMF uses the HIMETRIC mapping mode,
so that each pixel is interpreted as 0.01mm rather than
LOMETRIC / 0.1mm. Check this option if the resulting.EMF
file is going to be opened with a graphic program like
Corel Draw, since it will interpret the default size as
being 10 times smaller (resulting in less memory
consumption). |
| "Normalise" coordinate system |
When checked, Plot2EMF adjusts the coordinate system to
start at (0,0). If your drawing uses the IW (Input Window)
command, and the converted file is empty, try changing this
setting. It may help. |
| Enable multiple page support |
When checked, Plot2EMF creates a new.EMF file when a
PG; (page feed) command is encountered in the plot file.
NOTE: This option will be enabled only when Plot2EMF
has been registered! |
Copyright © 1999-2006, 2010 by James Greene. All
rights reserved. Information subject to change without
notice.
Options Dialog